Cisco CSS 11501 - Content Services Switch Getting Started Manual page 113

Chapter 5 Where to Go Next
Table 5-3 Cisco Content Services Switch Routing and Bridging Configuration Guide (continued)
Chapter
Chapter 6, Configuring
the Internet Protocol
OL-6037-01
Contents/Tasks
Internet Protocol (IP) configuration quick start.
•
Configuring an IP route. You can configure a static route, a default
•
static IP route, a blackhole route (where the CSS drops any packets
addressed to the route), or a firewall IP route.
Disabling an implicit service for the static route next hop, to forward
•
traffic to the next hop even when the next hop is unavailable.
Configuring an IP source route to enable the CSS to process frames
•
with information that overrides the default routing.
Configuring the IP record route to enable the CSS to process frames
•
with the IP address of each router along a path.
• Configuring box-to-box redundancy between two identically
configured CSSs.
Configuring IP equal-cost multipath (ECMP) selection algorithm and
•
the preferred reverse egress path.
Forwarding IP subnet broadcast addressed frames.
•
Configuring IP unconditional bridging to always make a bridging
•
decision on the received packets.
Configuring IP opportunistic Layer 3 forwarding to enable
•
opportunistic Layer 3 forwarding and allow the CSS to make Layer 3
forwarding decisions even if the Layer 2 packet destination MAC
address does not belong to the CSS.
Displaying IP configuration information.
•
Cisco Content Services Switch Getting Started Guide
Comprehensive CSS Documentation List
5-31