C H A P T E R 4 Maintenance And Upgrade Procedures; Removing And Replacing The Chassis Cover; Removing The Chassis Cover - Cisco ASA5500-HW - Hardware Accessory Kit Network Device Hardware Installation Manual

Removing and Replacing the Chassis Cover

Figure 4-1
1
Step 4 With the rear of the chassis facing you, pull the chassis cover forward then lift the cover up. (See
Figure
Place the cover in a safe place.
Step 5
Replacing the Chassis Cover
Do not operate the ASA without the chassis cover installed. The chassis cover protects the internal
Caution
components, prevents electrical shorts, and provides proper air-flow for cooling the electronic
components.
To replace the chassis cover, perform the following steps:
Place the chassis on a secure surface with the front panel facing you.
Step 1
Step 2 Lower the front of the chassis cover onto the chassis, slide it forward until it fits into place, and tighten
the thumbscrew to secure the chassis cover. (See
Cisco ASA 5500-X Series Hardware Installation Guide
4-2

Removing the Chassis Cover

1
Thumbscrew
4-1.)
Chapter 4 Maintenance and Upgrade Procedures
Figure 4-2.)