Starting/Stopping Encodes; Session Timeouts - Cisco 3005 - VPN Concentrator - Gateway Operation Manual

NOTE:

Starting/Stopping Encodes

To start an encode, click the Start link in the top right corner of any Cisco Media
Processor Web interface page. Once the encode starts, the encode status will change
to Running and the Start link will be replaced by a Stop link, which can be clicked to
stop the encode.
While an encode is running, the Web interface may be used to view settings, but the
Apply and Reload buttons will be grayed, except for those on the System Information
page and the Logging page. To make changes to other settings, stop the encode, then
apply changes and restart.

Session Timeouts

After a period of inactivity on the Web pages, your login session will time out and you
will be redirected to the login page. The default value is 15 minutes.
The web timeout is stored in the following registry setting:
HKEY_LOCAL_MACHINE\SOFTWARE\Inlet\Spinnaker\SessionTimeout.
C I SCO S3 0 00 / S 50 0 0 S ER I E S M E D I A PRO C E S SO R S
Configuration of Ethernet ports is only allowed if the media is
connected.
39