Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 9 Effects Manual page 25

On to FXBus 3. HereÕs where our breathy ßute sound is, and itÕs going through a delay FX preset
called 207*Adj Delay.
EditStudio:FXBUS|Size:1|Free:0|<>FXBus:3
FX3||207*Adj|Delay|||||||||Aux||||Mix
L|Wet/Dry|:50%wet|||Lvl:FXMod|Lvl:0.0dB
L|Wet/Dry|:50%wet|||Bal:0%||||Bal:0%
Allocation:Auto
<more||INPUT||FXBUS||AUXFX||OUTPUT|more>
Go into the FX Preset Editor, and press PARAM2, and on that page, youÕll see that the left and
right Delay times and the left and right Feedback settings are all under FXMod control.
EditFXPreset:PARAM2|||||Dual|MovDelay|||
L|Delay|||:FXMod||||R|Delay|||:FXMod|
L|LFO|Mode:ChorTri||R|LFO|Mode:ChorTri
L|LFO|Rate:0.90Hz|||R|LFO|Rate:0.50Hz|
L|LFO|Dpth:9.6%|||||R|LFO|Dpth:9.6%|
L|Feedback:FXMod||||R|Feedback:FXMod
L|HF|Damp|:25088Hz||R|HF|Damp|:25088Hz
<more||PARAM1|PARAM2|||||||||||||||more>
Go back out to the setup, and look at the bottom of the FXMOD2 page. Here we see the
L Feedback parameter is under the control of MIDI Controller 24 (Slider D), with a minimum of
17% and a maximum of 17+82=99%. Go to the FXMOD3 page and youÕll see the same
assignment is in place for the R Feedback parameter.
EditSetup:FXMOD3||||||||||||||All|Zones||
Bus:|Param:|||||Adjust:||Source:||Depth:
FX3||R|Feedback|17%||||||MIDI24|||82%
FX3||L|Delay||||50.0ms|||Foot||||||200.0
FX3||R|Delay||||74.0ms|||Foot||||||200.0
FX3||Aux|Lvl||||-61.0dB||MIDI27|||62dB
None|None||||||||||||||||OFF
<more||KDFX|||FXMOD2|FXMOD3|FXMOD4|more>
Also on this page, the Left and Right Delay times are controlled by the Foot Pedal, controller 4Ñ
CC Pedal 1 for K2600 keyboard users. Here it varies the left decay time between 50 and 250 ms,
and the right decay time between 74 and 274 ms.
Finally, the Aux Level from this bus, controlling the reverb send, is once again assigned to MIDI
controller 27, Slider G.
Basic Effects Mode
A Tour of Effects Mode
9-25