Dimension One Spas Nautilus Specifications page 2

Nautilus Specifications
27 in [67 cm]
Recommended location for
Electrical
Inlet
11 in [28 cm]
Hose Bib/
Water Drain
Hose Bib/
Water Drain
3 1/2 in [9 cm]
Note: Subject to change without notice.
1. Stereo/subwoofer optional.
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18" (45.7cm) clearances on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.
Doc1480- Rev -A Rev Date: 10/31/05
Nautilus
Architectural Specification
Top View of Spa
THIS 3 FOOT SQUARE AREA,
ON BOTTOM OF SPA, TO BE
SUPPORTED CONSISTENT WITH
THE EDGES OF SPA BASE.
See Note 5
Vent
Vent
56 1/2 in [143 cm]
67 1/2 in [171 cm]
91 1/2 in [232 cm]
Control
Spa Lip
Front View of Spa
Pedestal Base
75 in [191 cm]
89 in [225 cm]
91 in [231 cm]
Specification, Nautilus
16 in [41 cm]
16 in [41 cm]
Subwoofer
Equipment
Compartment
Vent
34 1/2 in [88 cm]
Door Extends
Under Spa Lip
Dimension One Spas
R16 in [R41 cm]
91 1/2 in [232 cm]
Shell
See Caution
91 in [231 cm]
Skirt
89 in [225 cm]
Pedestal
Base
23 1/2 in [60 cm]
35 1/2 in [90 cm]
32 in [81 cm]
16 in [41 cm]
Page 2 of 2