Using The Rsp8; Hub7 - Kurzweil HUB7 - REV A Manual

Chapter 1

Using the RSP8

The RSP8 is a remote control for Kurzweil's KSP8 multi-bus
signal processor that provides you convenient access to all of the
KSP8's front panel functions. The RSP8 also gives you eight
knobs for adjusting effect and other parameters, along with a
joystick for surround panning. You can also configure the knobs
and/or joystick to send MIDI controller values, to either a KSP8
or an external device.

HUB7

Chapter 2 of this manual describes the HUB7 repeater/
concentrator, which lets you use a single RSP8 to control up to
seven KSP8s, and also allows you to extend cable distances
between the RSP8 and KSP8(s).
1-1