Bissell PROHEAT - MANUAL 3 User Manual page 10

O
peration
Carpet cleaning continued
2. Remove formula tank from back of machine.
2a. fill the formula tank by first unscrewing the
cap and insert. Always use genuine BISSELL
cleaning formulas to maximize cleaning and
for the safety of your machine. Fill water up to
"WATER" line and then fill up to "FoRmULA" line
with BISSELL cleaning formula. Replace the cap
and insert. Place formula tank back into the slot
in the back of the machine for a snug fit.
3. Set custom clean Dial. Simply choose one
of the 4 settings (heavy traffic, normal clean,
light clean or water rinse) and the ProHeat
2X will adjust the right amount of cleaning
formula to mix with the heated water to fit
your cleaning need.
4. Set ReadyTools Dial to the floor cleaning setting.
5. Plug into a proper outlet and turn the
power and heater switches to the on ( I )
position. Allow 1 minute for the built-in
heater to warm-up before cleaning. The
ProHeat 2X will be fully warmed and will
provide optimal performance after one
minute of continuous heated cleaning.
6. cleaning Strokes. While pressing the spray
trigger, make one slow forward wet pass
and another one back. Let the built-in heater,
formula, and DirtLifter PowerBrushes do the
work for you. caution: Do not overwet.
Take care not to run over loose objects or
edges of area rugs. Stalling brush may result
in premature belt failure.
note: your machine is equipped with a
circuit breaker that will automatically shut
off the brush if a large or loose object is
caught in the brush roll. If that happens, be
sure to unplug your machine, remove the
foreign object, and then plug the machine
back in to reset the circuit breaker.
Release the spray trigger and make one
slow forward and backward pass over
the same area to remove any residual
dirty water and aid in drying. Repeat
cleaning passes pressing the spray trigger
until solution being pulled up appears clean.
Continue passes without pressing the
spray trigger until you can't see any more
water being pulled up.
16 10
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
2.
2a.
4.
FLOOR
CLEANING
Power Switch
3.
5.
Heater Switch