Dimension One Spas Arena Specifications page 2

2006 Arena Specifications
43 1/8 in [110 cm]
Recommended location for
Electrical
Inlet
34 5/8 in [88 cm]
Hose Bib/
Water Drain
3 1/2 in [9 cm]
Note: 1. Subject to change without notice.
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18" clearances on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.
Doc-1516 Rev -A Rev Date: 10/31/05
2006 Arena
Architectural Specification
78 in [198.12 cm]
Top View of Spa
THIS 3 FOOT SQUARE AREA
IS TO BE SUPPORTED
CONSISTENT WITH THE
EDGES OF THE SPA BASE.
Equipment
Compartment
See Note 5
87 in [221 cm]
Control Panel
37 1/4 in [94.61 cm]
Specification, 2006, Arena
Control Panel Front Side of Spa
Vent Typ 2 PL
Spa Lip
Pedestal Base
Door Extends
Under Spa Lip
86 3/8 in [219.39 cm]
Dimension One Spas
86 3/8 in [219 cm]
Skirt
87 in [221 cm]
Shell
See Caution
36 in [91 cm]
33 1/4 in [84.46 cm]
32 5/8 in [82.87 cm]
Page 2 of 2