Step 4: Connecting Devices To The Switch - NETGEAR FS752TP Hardware Installation Manual

Step 4: Connecting Devices to the Switch

The following procedure describes how to connect PCs to the switch's RJ-45 ports. The
FS752TP contains Auto Uplink technology, which allows the attaching of devices using either
straight-through or crossover cables.
Figure 6. Connecting Devices to the Switch
Connect each PC to an RJ-45 network port on the Switch front panel
Category 5 (Cat5) Unshielded Twisted-Pair (UTP) cable terminated with an RJ-45 connector
to make these connections.
Note: Ethernet specifications limit the cable length between the
switch and the attached device to 100m (328 ft.).
FS752TP Smart Switch
Power
Fan
PoE Max
LED Mode
Yellow=PoE
Green=Link/ACT
Select
Reset Factory
Ports 1-48, Link/Act Mode — Green=Link at 100M, Yellow=Link at 10M Blink=ACT
Defaults
Installation
23
Combo Ports
Ports 49-52 Link/Act Mode Green=1G, Yellow=10/100M Blink=ACT
(Figure 6). Use