Cli Reference Manual Updates - Dell PowerConnect M8024 Release Note

CLI Reference Manual Updates

OSPF
Title
maximum-paths <1-6>
show running-config
Title
show running-config interface [ {ethernet
<unit>/<port-type><port> | loopback <loopbackId>
| port-channel <Port-Channel Number>| tunnel
<tunnelId> | vlan <VlanId>}]
Commands Not Supported
Title
The following commands are not supported in the
Dell PowerConnect M8024 Series switches:
The duplex command in port aggregator
o
configuration mode.
The negotiation command in port
o
aggregator configuration mode.
The speed command in port aggregator
o
configuration mode.
The copper port commands:
o
Test copper-port tdr < port
number>
Show copper-ports tdr
PowerConnect M8024 Release Notes
Description
The input range of command "maximum-paths <1-2>" changes to
"maximum-paths <1-6>".
Description
This command has been enhanced so that it can be executed for a
specific interface, port-channel, or VLAN.
Description
These commands appear in the CLI Reference Manual but should not
have been included.
Page 4