Options:
1.
RWS 12/142
The RWS 12/142 features a rear hub width of 142mm for 12mm through axle which
only matches with the related 142mm rear dropouts in combination with the
12mm DT RWS.
219574 Dropout Set IDS 2 142/RWS 12
2. RWS 12/135
The RWS 12/135 features a rear hub width of 135mm for 12mm through axle which
only matches with the related 135mm rear dropouts in combination with the
12mm DT RWS.
219573 Dropout Set IDS 2 135/RWS 12
3. RWS 5/135
The RWS 5/135 features a rear hub width of 135mm for regular QR axles which only
matches with the related 135mm rear dropouts in combination with the 5mm DT RWS.
219572 Dropout Set IDS 2 135/RWS 5
Beside the complete sets as shown above for a change of the rear hub/axle system
you can also order the right side RD hanger separately via the Scott distribution in
case you need this to repair a damage on the RD hanger.
219575 Dropout Hanger right side IDS 2 135/RWS5
219576 Dropout Hanger right side IDS 2 135/RWS12
219577 Dropout Hanger right side IDS 2 142/RWS12
34
2011 SCOTT BIKE OWNERS MANUAL
FRONT FORK SET-UP/
CHANGE OF FRONT FORK
For the set up of the front fork please use the fork specific manual attached to the bike.
We recommend using front forks with a travel of 180mm (565mm from mid of axle -
top of crown), as this will not influence the geometry and alter handling of the bike.
Important:
No triple clamp forks are allowed on Genius LT!
PIVOT MAINTENANCE
The pivot and bearings on SCOTT Genius LT are extremely easy to maintain.
An external treatment with a grease spray after every bike wash is all you have to do.
We do not recommend heavy grease sprays since these will leave a film on the parts
which is difficult to remove. We recommend the same for the chain also.
If you have to change the bearings you can order them included in a service kit at your
local SCOTT dealer with
219565 Swingarm-Rep. Kit Genius LT
or buy them with international parts number as shown below in a hardware store.
- 4 x 6802 (15x24x5mm)
- 2 x 6803 (17x26x5mm)
- 2 x 61800 (10x19x5mm)
In case of a change of the bearings or of the rear swingarm you should contact your
local SCOTT dealer as you need special tools for disassembly and assembly.
35
Need help?
Do you have a question about the GENIUS LT and is the answer not in the manual?