Fluke MPC Instructions

Calibration Solutions
for Pressure
and Flow™
THE 110V VACUUM KIT INCLUDES
•
1 102381 [102034]
•
1 101322 [102382]
•
1 102123
•
2 102033
•
1 100109
•
1 101450-Z
•
The [ ] above denotes the part number required for a 220V Vacuum Kit
The PPC/MPC Vacuum Kit should be installed as illustrated above. Fill the vacuum pump with oil before using.
Read Fast Vac instruction sheet for additional information.
A three-way solenoid valve has been installed to protect the vacuum pump when turned off. When decreasing
pressure in a PPC the test gas is exhausted through the reference port. This ensures that the gas will not
exhaust into the pump and possibly cause damage. The valve is electrically connected to the vacuum pump
power switch and will be actuated when the pump is turned on.
When the vacuum pump is turned off, the reference or vacuum port of the PPC (or MPC) will be connected to
atmosphere bypassing the vacuum pump.
When the vacuum pump is turned on, the reference port of the PPC (or the vacuum port of the MPC) will be
connected to the vacuum pump enabling pressure below atmosphere to be generated.
PPC, RPM and MPC are trademarks, registered and otherwise, of DH Instruments, Inc.
Document 560004b
DH Instruments, Inc.
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Fast Vac Vacuum Pump
3-Way Solenoid Valve
Adaptor AN4F Swivel x 1/8 in. NPTM
Adaptor 1/4 in. Swage x 1/8 in. NPTM
Adaptor 1/4 in. Swage x 1/4 in. NPTM
1/4 in. O.D. Tubing (200cm)
PPC ™ /MPC ™ Vacuum Kit
Instructions
P/N 400922 (110V)
P/N 401160 (220V)
100109 or
040317
Tel 602.431.9100
Fax 602.431.9559
dhi@dhinstruments.com
www.dhinstruments.com