Quick Install - Fishman RARE EARTH BLEND User Manual

Quick Install

To temporarily install the pickup, loosen the clamps with a Phillips screwdriver.
Position the pickup in the soundhole, parallel to and as close to the end of the
fingerboard as possible. Gently re-tighten the clamps. For now, run the cable out
through the soundhole.
Precaution: Don't let the pickup cable rest on your guitar's finish for long
periods. The rubber jacket could interact with the finish and leave a
permanent mark.
If you travel with your guitar or store it for long periods with the pickup in place,
we strongly recommend that you have the endpin jack permanently installed in
the guitar. Installation instructions for professional installers are available from
Service & Support at www.fishman.com.