Connecting To The Gbic Module Ports; Connecting To A 1000Basex Gbic Module Port - Cisco 3524XL - Catalyst Enterprise Edition Switch Hardware Installation Manual

Chapter 2 Installing and Starting Up the Switch

Connecting to the GBIC Module Ports

Note

Connecting to a 1000BaseX GBIC Module Port

Caution
78-6456-03
Install the Gigabit Interface Converters (GBICs) as described in the
"GBIC Module Slots" section on page 1-10, and then connect to the
1000BaseX ports.
For detailed instructions on installing, removing, and cabling the GBICs
(1000BaseSX module or the 1000BaseLX/LH module), refer to the GBIC
documentation.
For detailed instructions on installing and cabling the GigaStack GBICs, see the
Catalyst GigaStack Gigabit Interface Converter Hardware Installation Guide.
Do not remove the rubber plugs from the fiber-optic port or the
rubber caps from the fiber-optic cable until you are ready to connect
the cable. The plugs and caps protect the fiber-optic port and cable
from contamination and ambient light.
Connecting to the GBIC Module Ports
Catalyst 3500 Series XL Hardware Installation Guide
2-19