Nokia 3595 - Cell Phone - GSM User Manual page 69

Personalize your phone
SET UP LIGHTS
If you are using your phone with an approved Nokia car kit, you can set lights to
On (display and keypad lights stay on) or Automatic (after 15 seconds, lights turn
off until the next key is pressed or the phone rings).
1 Place the phone into the car kit holder.
When the phone recognizes the accessory, the car kit icon
2 Press Menu 4-7-2 (Settings > Accessory settings > Handsfree).
3 Scroll to Lights, then press Select.
4 Scroll to On or Automatic, then press Select.
Note: Connecting your phone to a car kit automatically disables Keyguard.
Set up the loopset profile
The LPS-3 loopset gives people with T-coil equipped hearing aids the ability to
make and receive calls without noise interference.
Important: Refer to the booklet that comes with the LPS-3 for complete
instructions and safety information.
1 Plug the loopset plug into the jack in the bottom
of the phone, as shown in the illustration.
2 Press Menu 4-7-3 (Settings > Accessory
settings > Loopset).
3 Scroll to Use loopset, then press Select.
Scroll to Yes, then press Select.
4
Note: If you want to use the headset or TTY,
you perform steps 2-3, then select No to
deactivate the loopset profile.
Set up the TTY/TDD profile
You can connect your phone to a TTY/TDD using the Nokia TTY/TDD Adapter (HDA-9).
In order for your phone to recognize the TTY/TDD, you'll need to set up the TTY/TDD
profile, under Accessory settings.
Important: Some manufacturers of TTY/TDD devices suggest that the
phone be least 18 inches from the TTY/TDD device. Remember that when
connecting to any other device, read its user guide or contact its manufacturer
for detailed instructions and safety information.
1 Connect the TTY/TDD by a cable to the HDA-9 adapter.
62
appears.
Copyright © 2003 Nokia