Advertisement
A C O U S T I C
7
M O N I T O R
OPERATING INSTRUCTIONS - POWER SECTION
VOLTAGE SELECTOR
The Voltage Selector switch provides the option of powering the Acoustic Monitor Pro with either
115 volts AC or 230 volts AC. You must use a cord with the appropriate plug configuration for
the AC (mains) receptacles in the area in which you use it. If you are taking the Acoustic Monitor
Pro overseas, check with your dealer regarding the appropriate cord and plug configuration, or
contact Fishman Customer Service.
IMPORTANT:
When operating in the United States, always set the Voltage Selection switch for
115V using a 5 Amp Slow Blow Fuse. In Europe, set for 230V with a 2.5 Amp Slow Blow Fuse.
ON/OFF SWITCH
The Acoustic Monitor Pro's On/Off Switch has a "I" symbol for on and a "0" symbol for off.
Always turn the Acoustic Monitor Pro off before unplugging it.
AC POWER RECEPTACLE
Plug your AC (mains) power cord into this receptacle and the other end into a grounded outlet.
Do not modify the cord in any way. Do not cut off the grounding pin, and never use a 3-pin-to-2-
pin adapter unless you ground the adapter's grounding tab. If you use an extension cord, always
use a heavy-duty cord that is no longer than necessary.
NOTE:
If your AC (mains) cord is ever damaged or lost, replace it only with the same type.
CHANGING THE FUSE
The Fuse Holder is located to the left of the AC Receptacle (See Page 3,
Item #9). It is designed to hold a spare fuse. Insert a small screwdriver
into the small notch on the side of the Fuse Holder to remove it from the
AC Receptacle. DO NOT use a knife or sharp object. After replacing the
fuse, slide the Fuse Holder all the way into the Back Panel until it snaps
into place.
ACOUSTIC MONITOR PRO OWNER'S MANUAL
P R O
Advertisement
