Maintenance - iRobot DIRT DOG - MANUAL 2 Owner's Manual

Maintenance

To keep iRobot Dirt Dog running at peak performance, it is recommended that
you perform the following maintenance tasks every three uses:
Remove and empty
1
iRobot Dirt Dog's bin
Press button and
pull to remove bin
Clean iRobot Dirt Dog's cliff detect
2
sensors (use compressed air)
Sensors
TIP: Bin emptying and brush cleaning should be done after every 3- 5 cleaning
cycles depending on the amount of hair, dirt, and debris in your environment.
TIP: If you notice i Robot Dirt Dog picking up less debris from your floor, empty
the bin and clean the brushes.
Excessive build up of hair in i Robot Dirt Dog's brushes and bearings can
permanently damage iRobot Dirt Dog. Inspect brush bearings regularly.
Do not attempt to run i Robot Dirt Dog without the bearings. If you misplace
iRobot Dirt Dog's brush bearings, visit www.roomba.com.au to buy
replacement bearings.
14 iRobot Dirt Dog Owner's Manual
Clean iRobot Dirt Dog's brushes
3
A. Remove brush guard by pulling
B. Remove and clean iRobot Dirt Dog's
Brushes
Sensors
C. Remove and clean hair and dirt from
both yellow tabs
brushes. Remove brush caps and use
scissors to cut any hair wrapped around
the brush. Use the iRobot Dirt Dog
cleaning tool to comb hair from brush.
Brush
caps
(black)
iRobot Dirt Dog's yellow brush bearings.
Visit www.irobot.com/usetips
for instructional photos
Brush
bearings
(yellow)