Push Button Security - D-Link DHP-303 - PowerLine HD EN Starter User Manual

Section  - Installation
1. All Adapters
Plug in all the adapters to be configured.
2. First Adapter
Select the first adapter to be configured as the AP (Access Point). Press and hold the button until the AP light
starts flashing.
Press and hold the button
Note: It is recommended to choose any adapter connected to your Internet connection such as a router as AP,
or to the data or media source device such as a Media Center PC. There must be only one security key master
(AP) in the network.
The adapters memorize their security settings even after power is removed from the units. The security settings
of any adapter can be cleared by pressing the button until its AP LED is off. This will reset the unit back to the
factory default settings.
3. First Adapter
Wait until the AP LED stops flashing (up to 30 seconds).
4. First Adapter
The AP LED remains on and is now ready to start registering new adapters.
D-Link DHP-30 User Manual

Push Button Security

First Adapter
First Adapter