Other Problems; Tray Lock - JVC XVC26U - DVD/VCR Instructions Manual

Filename [XVC27U_11Trouble.fm]
XVC27U_11Trouble.fm Page 85 Friday, January 16, 2004 12:27 PM

OTHER PROBLEMS

SYMPTOM
1. The image of TV broadcast appears
distorted on the TV screen.
2. Whistling or howling is heard from the
TV during camcorder recording.
3. When scanning channels, some of
them are skipped over.
4. The channel cannot be changed.
5. Channel settings that were made
manually seem to have changed or
disappeared.
6. Even though Auto or Semiauto Clock
Set has been performed, the clock is
incorrect.
ATTENTION
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the AC power cord. Then plug it in again and turn the unit on. Take out the cassette. After checking the cassette,
operate the unit as usual.

Tray Lock

You can lock the disc tray to prohibit the unwanted disc ejection by children.
To lock the disc tray.
While the unit is turned off, press and hold 8, then press
tray is locked.
To unlock tray
While the unit is turned off, press and hold 8, then press x on the unit. "UNLOCK" appears on the display panel.
Page 85
POSSIBLE CAUSE
The unit leaves turned on and the DVD
deck is selected.
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been designated to
be skipped.
Recording is in progress.
After the manual settings were made,
Auto Channel Set was performed.
The clock setting data received from the
host channel is incorrect.
on the unit. "LOCK" appears on the front display panel and the disc
x
Masterpage:Right-No-Heading
EN
CORRECTIVE ACTION
Turn off the unit, or press VCR to select the
VCR deck, then press TV/VCR so that the
VCR indicator disappears from the front
display panel.
Position the camcorder so its microphone
is away from the TV.
Turn the TV's volume down.
If you need the skipped channels, restore
them. ( pg. 27)
Press PAUSE (9) to pause the recording,
change channels, then press PLAY (4) to
resume recording.
Perform manual setting again.
Select a different host channel during
"Semiauto Clock Set" ( pg. 25), or
perform "Manual Clock Set" (
16 January 2004 12:27 pm
85
pg. 25).