Marantz SA-11S3 Owner's Manual page 30

ENGLISH
[USB/iPod]
Problem Cause
"USB OC" appears • The voltage able to be
on the display. supplied from this unit via
the USB memory device
has been exceeded.
"Empty" appears on • No file able to be played on
the display. this unit exists.
The sound of the USB • The amplifier and speakers
memory device being are not connected properly.
connected is not
heard.
• The amplifier power is not
ON.
• The amplifier's function
or selector switch is not
set to "CD" or "AUX" or
such (to whatever you have
connected this unit to).
• The amplifier's volume
control is set at the
minimum level.
27
Corrective action Page
• The USB memory device –
is not supported. Please
use a USB memory
device with an operating
current that is less than
1 A.
• To clear the "USB OC", –
remove the USB memory
device and turn this unit
off and on.
• Check supported formats. 18
• Connect the cables –
correctly. (See the
instruction manual for the
amplifier.)
• Turn the amplifier power –
ON. (See the instruction
manual for the amplifier.)
• Switch the amplifier's –
function or selector
switch to "CD" or "AUX"
or such (to whatever you
have connected this unit
to). (See the instruction
manual for the amplifier.)
• Adjust the amplifier –
volume. (See the
instruction manual for the
amplifier.)
Problem Cause
The sound of the iPod • The amplifier and speakers
being connected is are not connected
not heard. correctly.
• The amplifier power is not
ON.
• The amplifier's function
or selector switch is not
set to "CD" or "AUX" or
such (to whatever you have
connected this unit to).
• The amplifier's volume
control is set at the
minimum level.
Reading of USB • When connecting a high-
memory device takes capacity USB memory
time. device, it will take time
to read depending on its
capacity. Several minutes
may be required for reading
when using a high-capacity
device.
Power fails to switch • The unit's power switch
on when the remote is off.
controller's X CD
is
pressed.
Corrective action Page
• Connect the cables 10
correctly. (See the
instruction manual for the
amplifier.)
• Turn ON the power to –
the amplifier. (See the
instruction manual for the
amplifier.)
• Switch the amplifier's –
function or selector
switch to "CD" or "AUX"
or such (to whatever you
have connected this unit
to). (See the instruction
manual for the amplifier.)
• Adjust the amplifier –
volume. (See the
instruction manual for the
amplifier.)
• Wait until reading is –
completed.
• Press the unit's power 12
operation switch.
• Or, press the unit's 12
power operation switch,
then press the remote
controller's X CD
.