Brick Panels - Desa KC42N Series Owner's Operation And Installation Manual

FIREPLACE
INSTALLATION
Continued
4. Remount the new frame at the hinge with five
new screws before closing door. This will
ensure seating of the gasket.
5. Close glass door frame. Lock latches by placing
the bar under the tab on door and pushing down
and back on latch (see Figure 42, page 25).
6. Replace screen/rod assembly by reversing
step 1.
7. Replace louvers by reversing procedure
under Removing Louver Panels, page 25.
Cleaning Glass Door
See Cleaning and Maintenance on page 31.
INSTALLING LAVA ROCK AND
GLOWING EMBERS
It is very important to keep logs exactly as
installed. Do not modify logs. Only use log set
designed for this fireplace.
WARNING: Logs are unitized
and not attached to the burner.
Do not handle log assembly by
top logs. Always pick up by the
bottom.
Open louvers, remove screen, unlock door latches
and open glass door. See Removing Glass Door,
steps 1 and 2, page 25.
1. Pull ember material apart into pieces no larger
than a dime. Place these pieces loosely and spar-
ingly directly onto the exposed front section of
the burner (see Figure 43). This will create
the glowing ember appearance as the flame
touches the ember material. Do not block air
slots by using too much ember material in one
area. It is not necessary to use all of the ember
material provided.
2. Pour lava rock onto plenum but not onto flat
burner. It is not necessary to use all of the lava
rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
3. Close glass door, lock door latches, replace
screen and close louvers (see Removing Glass
Door, steps 5 through 7).
26
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Andiron
Ember Material
Figure 43 - Placing Ember Material on
INSTALLING BRICK LINER MODELS
BL42DA(SA) AND BL42DHA(SA)
been running, turn off unit. Let
cool before installing brick liner.
You may purchase brick liner from your local
retailer or see Accessories, page 42.
brick panels with two hands.
Do not force brick panels into
place. Excessive force will break

brick panels.

1. Remove top and bottom louvers to allow ac-
cess to door latches.
2. Unlock door latches and open glass door. See
Removing Glass Door, steps 1 and 2, page 25.
3. Carefully remove lava rock and ember
material.
4. Remove andiron assembly from plenum by
removing screws.
5. Carefully lift logs and ember pod from
burner
6. Remove screws that attach plenum to burner to
remove plenum.
7. Remove three screws from deflector shield on
the inside top of firebox. Set shield and screws
aside.
www.desatech.com
WARNING: The glass door
Burner
WARNING: If fireplace has
CAUTION: Always handle
Plenum
116239-01F