4. In the terminal emulator, connect to controller A.
5. Press Enter to display the CLI prompt (#).
6. At the prompt, type the following command to set the values you obtained in Step 1
for each Ethernet management port, first for controller A and then for controller B:
set network-parameters ip address netmask netmask gateway gateway
controller a|b
where:
address is the IP address of the controller
■
netmask is the subnet mask
■
gateway is the IP address of the subnet router
■
a|b
■
For example:
# set network-parameters ip 192.168.0.10 netmask 255.255.255.0
gateway 192.168.0.1 controller a
# set network-parameters ip 192.168.0.11 netmask 255.255.255.0
gateway 192.168.0.1 controller b
7. Type the following command to verify the new IP addresses:
show network-parameters
Network parameters, including the IP address, subnet mask, and gateway address
are displayed for each controller.
8. Disconnect from the CLI and exit the emulator.
52
HP StorageWorks 2012fc Modular Smart Array user guide • March 2008
specifies the controller whose network parameters you are setting