Desa Comfort Glow LFP33PR Owner's Operation And Installation Manual page 14

UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued
OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORY RM4
Installing Remote Receiver Unit
1. Disconnect switch wires from the con-
trol valve.
2. Remove screws and nuts attaching
switchplate. Save screws and nuts to
attach receiver.
3. Remove switch plate (see Figure 27).
Discard after removing.
4. Install remote receiver unit onto remote
switch bracket using screws and nuts
removed in step 2. See Figure 28
5. Route wires through hole in the upper
portion of the switch plate (Figure 28).
Connect wires as shown in Figure 29.
(Black and blue wires are not used for
this application.)
Remote Switch
Bracket
Screw
Switch Plate
Wires
Figure 27 - Switch Plate and Wiring
Harness
Screws
Remote Receiver
Figure 28 - Installing Remote Receiver
LFP33PR
White Wire
From Receiver
Figure 29 - Connecting Wires
INSTALLING BATTERIES
FOR RM4
Four AA and two AAA batteries (not in-
cluded) are required to operate this heater
with the wireless hand held remote control
set. AA batteries must be installed in the
receiver and AAA batteries in the hand-held
remote control unit.
batteries.
Installing Batteries in Receiver
Ignitor
1. Locate back of receiver behind the re-
mote switch bracket under the firebox
bottom.
2. Slide the battery door off of the receiver
in the direction of the arrow on the door.
3. Insert the four AA batteries according
to Figure 30.
4. Slide the battery door back into position.
Terminal
Wires
Remote
Receiver
Battery Door
Figure 30 - Installing Battery in Remote
Receiver
Nuts
Valve
Red Wire From
Receiver
Only use alkaline
Note:
+
+
-
-
-
+
+
AA Batteries
14
Installing Batteries in Hand-Held
Remote Control Unit
1. Remove battery cover on front of re-
mote control unit following direction
of arrow.
2. Insert two AAA batteries following dia-
gram in battery housing area.
3. Replace battery cover onto remote con-
trol unit.
Remote
AAA
Control Unit
Batteries
-
+
+
Battery
-
Cover
Figure 31 - Installing Battery in Hand-
Held Remote Control Unit
Battery
Housing
104888