4
Installing LiveCycle Products
This chapter applies to all LiveCycle security products.
This chapter describes how to use the installation program to install LiveCycle Document Security,
LiveCycle Policy Server, or LiveCycle Reader Extensions on a Windows or Linux operating system.
Before you install the product, you must ensure that your environment includes the software and
hardware required to run LiveCycle products. You should also understand the installation options and
have prepared the environment as required. (See
If you are installing to a location where a LiveCycle product is already installed, install the new product, run
Configuration Manager to reassemble the products, undeploy the deployed product from the application
server, and then redeploy the files to the application server.
To install using the turnkey method, see
page
20.
Performing the installation
When you run an installation program, you need the following information:
The serial number for the product you are installing.
●
The type of installation and configuration you are performing. (See
●
configuring, and deploying LiveCycle products" on page
When installing on Linux, the installation program uses the logged-in user's home directory as a
temporary directory for storing files. As a result, messages such as the following may appear in the
console:
WARNING: could not delete temporary file /home/<username>/ismp001/1556006
When you complete the installation, you must manually delete the temporary files.
Caution:
Tip:
To improve the speed of the installation, disable any on-access virus scanning software for the
duration of the installation.
Ensure that the temporary directory for the operating system that you are using has a minimum
of 800 MB of free space available for the installation program:
(Windows) TMP or TEMP path as set in the Environment Variables
●
(Linux) Logged-in user's home directory
●
"Before You Install" on page
"Installing LiveCycle Products Using the Turnkey Installation" on
10.)
9.)
"Methods for installing,
33