Advertisement
P L E A S E R E A D A N D S AV E T H E S E
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
When using electrical appliances, basic safety precautions should
use of attachments not recommended or sold by The Holmes
always be followed to reduce the risk of fire, electric shock, and
Group may cause hazards.
injury to persons, including the following:
13.DO NOT use outdoors.
1. Read all instructions before using the appliance.
14.To prevent a possible fire, DO NOT block air intakes or exhaust
2. To avoid fire or shock hazard, plug the appliance directly into
in any manner. DO NOT use on soft surfaces, like a bed, where
a 120V AC electrical outlet.
openings may become blocked.
3. The heater is hot when in use. To avoid burns, DO NOT let bare
15.To disconnect heater, turn controls to OFF, then remove plug
skin touch hot surfaces. If provided, use handles when moving
from outlet.
this heater. Keep combustible materials, such as furniture,
16.Avoid the use of an extension cord because the extension cord
pillows, bedding, papers, clothes, and curtains at least 3 ft
may overheat and cause a risk of fire. However, if you have to
(0.9 m) from the front of the heater and keep them away from
use an extension cord, the cord shall be No.14 AWG minimum
the sides and rear.
size and rated not less than 1875 watts.
4. DO NOT run cord under carpeting. DO NOT cover cord with
17.If the heater will not operate, see specific instructions on
throw rugs, runners, or the like. Arrange cord away from
Auto Safety Shut-off.
traffic area and where it will not be tripped over.
18.DO NOT attempt to repair or adjust any electrical or
5. This heater is not intended for use in bathrooms, laundry areas
mechanical functions on this unit. Doing so will void your
and similar indoor location. NEVER locate heater where it may
warranty. The inside of the unit contains no user serviceable
fall into a bathtub or other water container.
parts. All servicing should be performed by qualified
6. Extreme caution is necessary when any heater is used by, or
personnel only.
near children or invalids, and whenever the heater is left
19.Discontinue use if plug or outlet is hot. It is recommended that
operating and unattended.
the outlet be replaced if plug or outlet is hot to touch.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and not the cord.
PLEASE READ AND SAVE
9. DO NOT insert or allow foreign objects to enter any
THESE IMPORTANT
ventilation or exhaust opening as this may cause an electric
shock or fire, or damage the heater.
SAFETY INSTRUCTIONS
10.DO NOT operate heater with a damaged cord or plug, or after
the heater malfunctions, has been dropped or damaged in any
manner. Return appliance to manufacturer for examination,
electrical or mechanical adjustment, or repair.
TECHNICAL SPECIFICATIONS
11.A heater has hot and arcing or sparking parts inside. DO NOT
• Wattage: 1500W (+5% –15%)
use it in areas where gasoline, paint, or flammable liquids are
• Working voltage: 120V AC/60Hz
used or stored.
12.Use appliance only for intended household use as described in
this manual. Any other use not recommended by The Holmes
Group may cause fire, electric shock, or injury to persons. The
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current) PLUG (a plug having one blade wider
than the other). This plug will fit into the power outlet only
one way. If the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact qualified personnel to
install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY
F E AT U R E S - O P E R AT I O N S
PRE-OPERATING INSTRUCTIONS
FIGURE 1
B
A
C
D
1. Carefully remove your heater from the box. Please save the
carton for off-season storage.
A. MODE/OFF BUTTON
2. Place heater on firm level surface.
B. HIGH POWER
3. Avoid overloading your circuit by not using other high
C. LOW POWER
wattage appliances in the same outlet. At 1500 Watts, on
/Off
D. SET TEMPERATURE
high, this unit draws 12.5 Amps.
LIGHTS
OPERATING INSTRUCTIONS
Oscillation
Your heater is equipped with a technologically advanced
AUTO SAFETY SHUT-OFF WITH INSTANT
1Touch™ electronic thermostat. You can set the heater to run
TIP-OVER PROTECTION
continuously in manual mode or set the 1Touch™ thermostat to
your desired temperature setting. The 1Touch™ thermostat will
This heater is equipped with a patented, technologically
automatically turn the heater ON or OFF depending on the
advanced, safety system that requires the user to reset the
preset comfort level. The comfort level ranges between 60˚and
heater if there is a potential overheat situation. When a potential
80˚ Fahrenheit in a 5˚ increments.
overheat temperature is reached, the system will automatically
shut the heater off. It can only resume operation when the user
Manual Mode Instructions:
resets the unit.
1. Plug the heater into a 120V AC electrical outlet.
TO RESET THE HEATER:
2. To start the unit, press the MODE/OFF button once for the
1. Unplug the heater and wait 10 minutes for the unit to cool
HIGH manual setting. (See Fig. 1)
down.
3. Press the MODE/OFF button again for the LOW manual
2. After the 10 minutes, plug the unit in again and operate
setting. (See Fig. 1)
normally.
4. To stop the unit, press and hold the button for two seconds or
TIP- OVER SHUT-OFF:
keep pressing the button until all the temperature
When the unit is accidentally knocked over, it will instantly shut
indicators are OFF.
off. To reset, simply place the heater in an upright position and
NOTE: The Power Light will remain lit during
it will operate normally.
operation. In Manual Mode, only the LOW or HIGH
power light will be lit.
F E AT U R E S - O P E R AT I O N S
1TOUCH™ THERMOSTAT INSTRUCTIONS
REMOTE CONTROL INSTRUCTIONS
To take advantage of the 1Touch™ Thermostat, continue to press
The remote control allows you to control the
the MODE/OFF button until the desired temperature is set in
power, mode, and temperature settings of this
either the HIGH or LOW setting. When ambient temperature rises
unit. Please see "Manual Mode" and "1Touch™
above the set temperature, the heater will stop. When the
Thermostat" instructions above.
ambient temperature drops below the set temperature, the
Insert 2 AAA batteries (not included) into the
heater will turn on automatically.
remote control.
NOTE: When the 1Touch™ thermostat is set, either the
NOTE: To shut this unit off with the
HIGH or LOW power light, and the set temperature
remote control you can scroll through all settings until
light will remain lit during operation. (See Fig. 1)
all temperature and power lights turn off, or press and
hold the MODE/OFF button for 2 seconds.
NOTE: It is normal for the heater to cycle ON and OFF
as it maintains the preset temperature. To prevent the
BATTERY WARNING:
unit from cycling, you need to raise the thermostat
setting.When the preset temperature is made, the fan
• DO NOT mix old and new batteries.
will run for 30 seconds without heat. This cool down
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable
process ensures an accurate and consistent temperature
(nickel-cadmium) batteries.
reading.
OSCILLATION INSTRUCTIONS
NOTE: 1Touch™ has memory. The 1Touch™ thermostat
will remember the previous temperature setting after
1. Select the desired control setting and press or switch the
the unit has been turned off. However, if the unit is
oscillation button to the ON position.
unplugged, or the unit is turned off, the 1Touch™
2. To stop oscillation, press or switch the oscillation button to OFF.
thermostat will be reset and will no longer remember
3. Please do not manually turn the unit; it is designed to turn
the previous setting.
only by motorized oscillation.
Advertisement
