Dell DR4000 Release Notes page 9

Table 2. Known Configuration Issues and Workarounds for Release 1.x
Issue Description
4256 The DR4000 system only supports
NFS: NFS Version 3 and TCP .
DR4000
Some other operating systems (such
returns an
as Solaris and HP-UX) mount their
incorrect
containers using the UDP protocol
error message
and NFS using the TCP protocol.
to the client
However, these clients are not
for NFSv4 -
supported by the DR4000 system.
mount/UDP
(1.1).
5601 The DR4000 system reports
Authenticati authentication failure back to the
on failure client if it cannot contact the domain
when controller.
entering in
username
and password
correctly.
6957
This condition can occur when an
system --init administrator has enabled
failed with replications, there were active
"Failed to snapshots, and the DR4000 CLI
unmount commands were entered to reset the
/dev/sbd3". system to its factory settings:
maintenance --filesystem --
wipe_data system --init
During the filesystem initialization,
the mkfs.vxfs are not properly
unmounting all the snapshots.
DR4000 System Release Notes, Release 1.0
(continued)
Workaround/Solution
There is no workaround or
solution (OS clients must
support NFS Version 3 and
TCP).
If the administrator is sure that
the username and password are
correctly entered, log into the
DR4000 CLI and enter the
following command:
network --ping
--destination <fully qualified
domain name of domain>
Use the Factory Reset option in
the Restore Manager (RM)
program, to reset the DR4000
system to its factory
configuration.
WARNING:
The Factory Reset
mode deletes all DR4000
system data. Factory Reset
mode should only be used
when the data is no longer
needed.
NOTE:
Contact Dell Support for
assistance prior to using the RM
program.
7