Hp P6000 Command View Upgrade Support - HP 3000 - 37XE System Reference

2.1 HP P6000 Command View upgrade support

This table shows upgrade support for HP P6000 Command View versions. A bullet (•) indicates you can perform an upgrade from the
version in the FROM column to the version in the TO column without removing the earlier version. A blank cell (or if an HP P6000
Command View version is not listed) indicates an upgrade to a later version (without removing the earlier version) is not supported. For
unsupported upgrade paths, you must remove the previous version using Windows Add/Remove Programs, reboot the management server,
and install the applicable version listed below.
NOTE: For supported upgrade paths, it is possible that a reboot may occur automatically during the upgrade.
FROM HP P6000
Command View version
8.0
8.0.1
8.0.2
9.0
9.0.1
9.1
9.2
1
9.2.1
9.3
9.4
1
You must have 9.2 installed before you can upgrade to 9.2.1.
TO HP P6000 Command View version
8.0 8.0.1 8.0.2
• •
•
9.0 9.0.1 9.1
• • •
• • •
• • •
• •
•
9.2 9.2.1 9.3
•
•
•
•
•
•
• •
•
9.4
•
•
•
8