Table of Contents
Advertisement
Remote control
Problem
The remote control does not
work properly.
■ PLAYER SECTION
iPod
• Supported iPod .....iPod (5th generation), iPod classic, iPod
nano, iPod touch, iPhone, iPhone 3G, iPhone 3GS
AUX IN
• Input connector
............STEREO L/R: 3.5 mm (1/8 in) STEREO mini Jack
■ AMPLIFIER SECTION
• Maximum output power .......................... 4 W + 4 W + 8 W
• Driver unit ...................4 cm (1 5/8 in) full-range driver × 2
5.5 cm (2 1/8 in) woofer + SR-BASS × 1
■ TUNER SECTION
• Tuning range
FM ...................................................87.50 to 107.90 MHz
AM ......................................................... 530 to 1710 kHz
■ TRANSMITTER SECTION
• Frequency ............................................................... 2.4 GHz
• Transmission range.......................... Approx. 20 m (65.6 ft)
• Number of units which can be simultaneously
transmitted to ................................................... Up to 7 units
(depending on the circumstances)
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
the unit and the remote control.
Wireless communication is not
established when SOURCE is set to
iPod.
SPECIFICATIONS
■ GENERAL
• Power Supply........................................... AC 120 V, 60 Hz
• Power consumption .....................................................10 W
• System off consumption .............................................3.5 W
• Standby consumption...................................... 1.0 W or less
• Dimensions (W × H × D)...................260 × 90.3 × 141 mm
• Weight......................................................... 1.2 kg (2.6 lbs.)
Specifications are subject to change without notice.
(6 Ω 1 kHz, 10% THD)
iPod™, iPhone™
iPod is a trademark of Apple Inc., registered in the U.S. and
other countries.
iPhone is a trademark of Apple Inc.
"Made for iPod" means that an electronic accessory has been
designed to connect specifically to iPod and has been
certified by the developer to meet Apple performance
standards.
"Works with iPhone" means that an electronic accessory has
been designed to connect specifically to iPhone and has been
certified by the developer to meet Apple performance
(without interference)
standards.
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
SPECIFICATIONS
Solution
For information on the remote control
operation range, refer to "Using the remote
control" (☞ P. 1).
Change the lighting or orientation of the
unit.
Replace the battery with a new one
(☞ P. 1).
Remove the obstacles.
Play the iPod to establish wireless
communication (☞ P. 6).
(10 1/4 × 3 1/2 × 5 1/2 in)
11
En
Advertisement
Table of Contents
