Mounting The Unit - Bosch LTC 1461-21 Installation Manual

Flexidome
XT

4 Mounting the unit

The unit is mounted in several different ways depending on the type of
surface, whether an electrical box is used and whether the connection is via
the rear or the side (raised from the surface).
Caution
Installation should only be performed by qualified service
personnel in accordance with the National Electrical Code or
applicable local codes.
If the connection is from the side, use the optional raised mounting base
(LTC 1347) and mount the Flexidome
Tips
• Use the mounting base as a template to mark the position of the four
screw holes and the center hole for the wires.
• Ensure that the mounting surface is level and smooth so that the rubber
gasket at the back of the mounting base forms a watertight seal.
• Partially screw in two screws for the keyholes and use them to
temporarily hang the camera while the connections are made.
The following drawings show the different ways of mounting the unit.
Figure 4-1
Solid surface
(four pre-drilled
8mm holes)
Four screws
(supplied)
Bosch Security Systems | 2005-02 | V2.0
| Installation Manual
Rear connection - solid surface
onto this base.
XT
Wires
EN | 7
Mounting
base