Connections - Technics ST-500 Operating Instructions Manual

1I
FM antenna terminal is as shown belOW:
l
Be sure the shield braid contacts the clamp.
Stereo connection cable (included)
"--~..:::..~~~~~~~~~C~~~~·
(L)
The indication AM used here includes
both MW and LW lor Model ST-500l.
Connections
Note: An outdoor antenna should be installed by a competent technician only.
FM ouldoor antenna
(option)
FM indoor antenna
(included)
(Necessary in mountainous regions, inside
reinforced-concrete buildings, etc.)
75-ohm coaxial
cab Ie (option)
1
[J'" LJBJ:=t
J
20 mm
(25/32 )
10 mm
(3/8 )
-
Clamp
Shield braid
Center conductor
~'~(
T~
or tape
I
or
~
---­
Installalion of Ihe AM loop anlenna
1. Pay attent ion to the following points when attaching the anten­
na.
• Do not attach it horizontally (to do so would impair recep ­
tion).
• Do not attach it close to metal surfaces (to do so would
result in noise).
When attaching the antenna to a wal!, column
or rack
Find the height and direction of the anten na where
reception is best and then fix it vertically to the wall,
rack, etc.
J~
AM loop
antenna (included)
_,.~.I
Column
i
6
>
,",,~.
i
AM anten na
holder (A) (included)
• Attach to a wall (using tack or tape) facing in direction
(.~-"
of best reception.
• Tack should not contact internal antenna wire.
Tack or tape
i :
• For best reception sound quality, an FM outdoor anten ­
/'/
i
na is recommended.
,.JJ.,
• Disconnect th is antenna if an FM outdoor anten na is in ­
stalled.
Control input terminal (CONTROL INPUT):
This terminal is used for the connection of a timer for
the purpose of controlling the tuner by means of an
external control signal.
Household
AC outlet
.
"
..
-~
AC power supply cord (included)
Configuration of AC power supply
cord differs according to area.
To tuner input terminals
(R)
of the amplifier
AM loop anlenna
(included)
If th is antenna is not properly instalied,
AM broadcasts will not be received.
Be sure to connect the AM loop antenna
even when an outdoor antenna is used.
AM ouldoor antenna
(option)
5
~
12 m (16
~
40 ft.) (Necessary in mountainous regions, in ­
side reinforced-concrete buildings, etc.)
Use5 - 12m(16 - 40 ft.) of vinyl ­
covered wire horizontally at the window.
'nyl-covered wire (option)
• Do not attach it close to power cords, speaker wires, etc. (to
do so would result in noise).
• Do not attach it close to a tape deck (when the tape deck is
being used, chirping or beeping sounds may be received).
2. Connect the AM loop antenna to the AM 3ntenna terminals
located on the rear panel of the unit.
When attaching the antenna to the unit - - - ,
This type of installation may cause impaired recept ion
or result in signa I noise. If possible, attach the antenna
to the rack, a wall, or a column.
Move the anten na toward the right or left to find the
point of best receptio
ll .
AM loop anten na
(included)
- 4 ­