Sherwood CD-5090 Operating Instructions Manual page 17

Making manual edit
In the stop mode, select the manual edit
1
mode.
EDIT EDIT
EDIT
or
Press the PROGRAM/REVIEW button
3
to manually edit the tracks to be
recorded.
PROG/REV
or
Press the EDIT button to start editing for
5
the side B.
EDITEDIT
or
2
Select the tape length like the auto edit.
Edit the tracks for the side A repeating
4
steps 2 and 3 in "PLAYING TRACKS IN
ANY SEQUENCE(PROGRAMMED
PLAY)" procedure on page 14.
Notes
During manual edit, if the "-" indicator in the
time display disappears and " " flickers, it
means that the total time of the edited tracks
exceeds the tape length. So you should edit again.
When a track with a number greater than 30 is edited,
the time display may show "---:--".
Edit the tracks for the side B in the same
6
manner.
If the PLAY button is pressed after editing the
tracks, play starts from the first track of the side A
for recording.
If all tracks of the side A have been played, press
the PLAY button to start play from the first track of
the side B for recording.
When this unit is connected to Sherwood
compatible cassette deck such as DD-5090C
controlled remotely by DIGI LINK system, if using
the CD synchro record function on the DD-5090C,
recording a CD is easier. (refer to the DD-5090C's
operating instruction)
17