Table of Contents
Advertisement
Using the remote control
Ensure that DVD mode is selected using the
button.The 'DVD' LED above the
Dims or turns the DV27A's display on or off.Turning the display
off generally gives a slight improvement in sound quality.
Pressing
once turns the display off; twice dims the display.
DISP
To restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 14).
Press
to cycle through the repeat play options;
RPT
alternatively use the 'Play modes' menu.
Fast play and Skip chapter/tracks
Play fast (
) and Skip (
in both directions (see page 10).
Opens and closes the disc tray.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
menu pages. Confirm your selection with the
Pause ( ), Play ( ) and Stop ( ) (see page 10).
These buttons are described on the next page.
CD/DVD
toggle
CD/DVD
button is lit briefly
CD/DVD
when DVD mode is selected.
DISP (display)
CD
DVD
CD
a third time.
DISP
DVD
A–B
DISP
A-B
RPT (repeat)
RPT
) chapters/tracks
OPEN
OPEN
button.
OK
Playback control
P
MODE
Advanced controls
ZOOM
ANGLE
0–9 keypad
This allows direct access to individual tracks on audio CDs.To select
a track, press the corresponding keypad button followed by
tracks greater than 9, enter the digits in sequence. For example, to
play track 15, press 1, then 5, then
Standby
CD/DVD REMOTE
Press
STANDBY
Note that Arcam CD players are not controlled by this button.
CLEAR
1
2
3
Use
CLEAR
numeric field (see pages 13–14).
4
5
6
PROG (program)
7
9
8
You can program a selection of up to 20 chapters/tracks from
a disc to play in any order. Press
0
CLEAR
PROG
menu (see page 13 and 15).
Page Up/Down (DVD-audio)/Slow play (other discs)
DVD-audio: Some DVD-audio discs all the user to browse
through images (photographs of the artist, lyrics, etc.) while
music is being played. Use the
previous/next page. Note that this is not availble on all DVD-audio
discs.
OK
Other discs: Press
forward or backwards.There are four speeds of slow playback: 1/5,
1/4, 1/3 and 1/2. Press the button repeatedly to cycle through the
different speeds.To resume normal playback speed, press
NOTE: Slow play does not apply to audio CDs or DVD-audio discs.
MUTE
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (
effect on the audio output level of the DVD players.
SUBT
TITLE
MENU
AUDIO
MEM
RTN
SETUP
STATUS
SRCH
CR-314
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the FMJ badge on the
left of the front panel (where the IR receiver is located),
or the remote control may not work.
13
OK
. For
OK
.
to toggle the standby state of the DVD player.
within the 'Program' and 'Bookmark' menus to clear a
to access the 'Program'
PROG
or
buttons to change to the
or
on the remote control to play slow
+
/
–
) controls and
MUTE
button have no
PLAY
.
Advertisement
Table of Contents
