How To Configure Your Wireless Printer, Using The One-Push Wireless Setting Mode - Brother HL-2170W Network User's Manual

How to configure your wireless printer, using the one-push
wireless setting mode
IMPORTANT
If you are going to connect the printer to your network, we recommend that you contact your system
administrator prior to installation.
a
Press the wireless setup button located at the back of the machine for less than 2 seconds as show in
the illustration below. This will put the printer in one-push wireless setting mode. This feature will
automatically detect which mode your access point uses for one-push configuration
(SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™) of your printer.
Note
• Use a pointy object such as a ballpoint pen to press the button.
• If you press the button for 3 seconds or more, the printer will change to the PIN Method of the
Wi-Fi Protected Setup™ mode. See How to configure your wireless printer, using the PIN Method of Wi-Fi
Protected Setup™ on page 80.
b
The printer starts the one-push wireless setting mode.
The printer searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™ or
AOSS™ for 2 minutes.
c
Put your access point in the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or the
AOSS™ mode, depending on what is supported by your access point. Please refer to the instruction
manual that came with your access point.
Wireless configuration using the one-push wireless setting mode (For HL-2170W)
6
6
70