Installation; Introduction; Packaging - A.O. Smith GWV - 120 Installation And Service Manual

is
3
3.1

Introduction

3.2

Packaging

Instruction manual GWV

Installation

Warning
Installation work should be carried out by an approved installation engineer
in compliance with the general and local regulations imposed by the gas, water
and power supply companies and the fire service.
The appliance may only be installed in a room that complies with the
requirements stated in national and local ventilation
regulations (1.3 "Regulations").
This chapter describes the installation activities to be carried out before you
actually start using the appliance
• Packaging;
• Environmental conditions;
• Technical specifications;
• Installation diagram;
• Water connections, Vented,
• Gas connection;
• Air supply and flue;
• Electrical connection;
• Checking the supply pressure and burner
For a possible conversion to a different gas category, see
conversion (4 "Conversion to a different gas
To avoid damaging the appliance, remove the packaging carefully.
We recommend unpacking the appliance at or near its intended location.
Caution
The appliance may only be manoeuvred in an upright position. Take care
that the appliance is not damaged after unpacking.
(9 "Starting and running"), namely:
pressure.
category").
19