Denon AVR-2310CI Owner's Manual page 38

ENGLISH
Setting items
Trigger Out When Setting for Zone (MAIN ZONE / ZONE2)
n
Select the condition for Trigger out is activated through linkage to the power of the zone set to
activating Trigger Out for "ON".
the input source, surround
When Setting for Input Source
n
mode, etc.
Activate trigger out when the input source set to "ON" is selected.
See "TRIGGER OUT jacks"
(vpage 19) for more Valid for the zone set to "ON" with "When Setting for Zone" .
information on trigger out.
When Setting for Surround Mode
n
Activate trigger out when the surround mode set to "ON" is selected.
Valid when the "MAIN ZONE" set to "ON" with "When Setting
for Zone" is selected, and when the input source set to "ON" with
"When Setting for Input Source" is selected.
Remote ID 1 / 2 / 3 / 4
Set when you operate
When using the AVR-2310CI with only the included remote control unit
another DENON AV amplifier
(RC-1117), use Remote ID "1" (default).
with the remote control unit
When using a separately sold remote control unit (RC-7000CI, etc.),
of the AVR-2310CI. Match
this function can be used. Match the ID setting of the remote control
the remote control unit you
unit and the receiver.
are using with the remote ID
of the AVR-2310CI.
232C Port Serial Control : Set when using an external controller.
Set when using an external 2Way Remote : Set when using a 2-way remote control unit.
controller or two-way remote
When using a DENON two-way remote control (RC-7000CI or RC-
control connected to the RS-
7001RCI, sold separately), set to "2Way Remote" .
232C terminal.
NOTE
When setting to "2Way Remote" , you can not use the RS-232C connector
as an external controller.
Dimmer • Bright : Normal display brightness.
Adjust display brightness of • Dim : Reduced display brightness.
the receiver. • Dark : Very low display brightness.
• OFF : Turns the display off.
Switching is also possible by pressing
Setup Lock • ON : Turn protection on.
Protect settings from • OFF : Turn protection off.
inadvertent change.
When "Setup Lock" is set to "ON" , the settings listed below can
no longer be changed. Also, "SETUP LOCKED!" is displayed if you
attempt to operate related settings.
・RESTORER
・MultEQ
・Dynamic EQ
Remote control
3
operation buttons
Setting contents
on the main unit.
・Dynamic Volume
・Channel Level
・Audio Delay
Displaying the menu
:
: Moves the cursor (Up/Down/Left/Right)
Cancel the menu
Making detailed settings (Manual Setup)
: Decision the setting : Return to previous menu