Image Setup - D-Link DCS-2210 User Manual

Configuration
In this section, you may configure the video image settings for your camera. A preview of the image will be shown in Live Video.
Enable Privacy
The Privacy Mask setting allows you to specify up to 3 rectangular areas
Mask:
on the camera's image to be blocked/excluded from recordings and
snapshots.
You may click and drag the mouse cursor over the camera image to draw
a mask area.Right clicking on the camera image brings up the following
menu options:
Disable All: Disables all mask areas
Enable All: Enables all mask areas
Reset All: Clears all mask areas.
Anti Flicker:
If the video flickers, try enabling this setting.
Mirror:
This will mirror the image horizontally.
Flip:
This will flip the image vertically. When turning Flip on, you may want to
consider turning Mirror on as well.
Power Line:
Select the frequency used by your power lines to avoid interference or
distortion.
White Balance:
Use the drop-down box to change white balance settings to help balance colors for different environments. You can choose
from Auto, Outdoor, Indoor, Fluorescent, and Push Hold.
Exposure Mode:
Changes the exposure mode. Use the drop-down box to set the camera for Indoor, Outdoor, or Night environments, or to
Moving to capture moving objects. The Low Noise option will focus on creating a high-quality picture without noise. You can
also create 3 different custom exposure modes. The Max Gain setting will allow you to control the maximum amount of gain to
apply to brighten the picture.
Denoise:
This setting controls the amount of noise reduction that will be applied to the picture.
Brightness:
Adjust this setting to compensate for backlit subjects.
D-Link DCS-2210/2230 User Manual

Image Setup

28