Setup Steps For Administrators; Installing The Blackarmor Nas 110 Server And Software - Seagate ST310005MNA10G-RK - BlackArmor 1 TB NAS 110 Centralized Network Attached Storage Server User Manual

Setup Steps for Administrators

If you are not a BlackArmor administrator, skip to page 26.

Installing the BlackArmor NAS 110 Server and Software

Before you begin:
• Ensure that your computer meets the requirements listed on page 8.
• Ensure that you have a solid, flat, stable surface for the server to sit on in an area with
reliable ventilation. Ensure that the server's vents will not be covered or blocked and that
the server is not placed near a heat source. Ensure that the server won't be in an area
where liquids may be spilled on it.
To install the BlackArmor NAS 110 server and software:
1. Use the Ethernet cable included in the kit to connect the BlackArmor NAS 110 server to a
switch or router on your local network. Connect the Ethernet cable to the Ethernet port on
the back of the server, as shown below.
Figure 4: Connect power and network cables
2. Use the power adapter included in the kit to connect the BlackArmor NAS 110 server to a
grounded power outlet.
BlackArmor® NAS 110 User Guide
Setup Steps for Administrators
Step 2
Step 1
18