Understanding The Network Settings View - D-Link DSN-500 Software User's Manual

7.1 Understanding the Network Settings View

In the Network Settings View, the Main Display shows the IP address and connection status of
the xStack Storage management port, Ethernet ports, and Link Aggregate Groups (LAGs) for
your xStack Storage system. If your system is equipped with dual controllers, all of these
settings will be automatically and transparently transferred to the redundant controller in
the event of a failover, without any changes or interruptions on your host servers.
If you click a management port in the Main Display, the Management Port tab lets you

view or change the network settings for the selected port and the Network Actions
panel allows you to ping from that management port.
If you click an Ethernet (iSCSI) port in the Main Display, the Port tab shows the settings

for the selected port and lets you change the MTU size and disable or enable the
network port. The Network Actions panel allows you to create a portal on the selected
port, replace the port with a VLAN-enabled port, and group ports.
If you click a LAG, the Link Aggregation Group (LAG) tab shows information about the

LAG and lets you change the LAG's MTU setting.
If you click an IP address below an Ethernet port in the Main Display, the Portal tab

shows the status of the selected portal. The Network Actions panel allows you to ping
from or delete the portal.
If you are using a DSN-5000 Series system with dual controllers and those controllers are

unable to bind, the Network Actions panel is replaced with an Unable to Bind action
panel that allows you to take corrective action.
102 Chapter 3 Managing Volumes
Figure 7-1. Network Settings View
If You Select This
Management Port...
Information about
the Selected Port
Appears Here