Advertisement
This procedure is used for uploading new Software into the FT
the CT-119 program cable. If you have the 8-pin mini-DIN PGM-SW (P0091526) refer to the page 4.
*Don't forget to write down (or save to a CF Card) any personal menu settings you have changed from the
default before you start. Please see the Data Management Operation Manual for the procedure to save your
settings to a CF card.
(1) Turn off the main power switch located on the back of the FT
supply for FT
9000MP and wait a minute, until the capacitors discharge) and remove the AC
DX
power cord.
(2) Connect the CT-119 cable's DB-9F connector to the serial port COM1 in the back of your
computer. Plug the mini-DIN connector of the CT-119 into the ACC jack connector on the rear
of the transceiver. Be sure that the arrow indicator on the mini-DIN plug is down. If you use a
USB to serial adapter, you might need to change the COM-Port number.
(3) Connect the AC power cord (in the case of the FT
(4) Turn on the main power switch located on the rear panel of the FT
power supply for the FT
(5) Now go to the desktop and find the FSW004 as shown below. Double-click the FSW004 icon,
displayed on the Program Screen.
(6) When the program opens, confirm that the file AH010N_V0521.SFL is highlighted; if not, click
on it to highlight it.
(7) Click on [WRITE] in the program window. A green status bar should appear below the [WRITE]
button to show the progress of the download. Do not interrupt the process until it completes.
(8) When the loading process is complete, an [OK?] box will appear. Click [OK?].
(9) Turn off the main power switch. Located on the rear panel of the FT
power supply for the FT
your computer and the ACC connector on the rear of the transceiver.
(10) Turn on the main power switch located on the back of the FT
supply for FT
9000MP).
DX
MAIN Software Update
ACC
9000MP). [NOTE: The radio will not show a display now.]
DX
9000MP. Remove the CT-119 cable from the DB-9F connector of
DX
9000 Amateur Transceivers using
DX
9000 (or turn off the power
DX
Main Power SW
9000MP connect the power supply cables).
DX
9000 (or on the top of the
DX
9000 (or on the top of the
DX
9000 (or on the top of the power
DX
Advertisement
