Hardware Installation
Unplug your PC's main power cord before installing VideoMate DVB-T
PCI card. Failure to do so may cause damage to your VideoMate DVB-T PCI
card and void your warranty.
1. Shut down your computer and unplug main power cord.
2. Remove the computer case cover.
3. Locate the ATX power switch pins on your computer case and trace the
wires to the power switch connector on your mainboard. The ATX power
switch cable is normally a twisted pair cable with a two-pin connector as
shown above.
On the mainboard, the ATX power switch pins are usually labeled "POWER
SW" or similar. It is vital to remember the position of these pins for a later step
in the installation process.
4. Unplug the ATX power switch cable
from the mainboard and connect it to
the connector named "Button" on the
VideoMate DVB-T PCI card, as
shown on the right.
Warning
Power Up Connections
Note
9