Preset Level; Bypass - DigiTech RP1000 - MANUAL 2 Owner's Manual

2. When the display prompts you with FaCt rst, release the Store button, which is now
flashing.
3. Press and hold the flashing Store button for 3 seconds until restOreD appears in the
display and release. The Restore procedure takes several seconds to complete; during the
procedure, the display will count up. After the Restore procedure is complete, the Expres-
sion Pedal calibration procedure will begin.
Expression Pedal Calibration
The Expression Pedal on the RP1000 needs to be recalibrated for use after you do a factory
reset. This calibration procedure automatically starts after the factory reset procedure is com-
pleted. (You can also start the calibration procedure by pressing and holding the currently active
preset's footswitch for about 5 seconds.) If the pedal's calibration fails, or if the pedal does not
function properly, it can be re-calibrated using the calibration procedure. This will not erase the
User presets. The procedure for calibrating the expression pedal is as follows:
1. Press and hold the currently active preset's footswitch until peDL CaL appears in the
display (bypass, tuner, and eXIt will be displayed before peDL CaL is accessed, after
about 5 seconds.)
2. When the Display prompts you with tOe Down, rock the Expression Pedal forward (toe
down) and press Footswitch 5.
3. When the Display prompts you with tOe up, rock the Expression Pedal back (toe up)
and press Footswitch 5.
4. The Display now prompts you to calibrate the V-Switch sensitivity (VsWitchxxx), where
XXX is the current V-Switch threshold. Rock the Expression Pedal forward and press
firmly on the toe once to turn the V-Switch on (WaH On), and again to turn the V-Switch off
(WaH OFF).
If the V-Switch is too sensitive, press the Up Footswitch to raise the threshold (range is
5.
0-199). The Down Footswitch decreases sensitivity. Keep testing the V-Switch sensitivity
and adjust the threshold until it only engages when you want it to (too sensitive a setting
will lead to the V-Switch falsely triggering on or off when using the Expression Pedal).
When the V-Switch sensitivity is set to your satisfaction, press Footswitch 5 to exit.
6.
Note: If the Display shows errOr, an error has occurred and steps 2 through 5 should be
repeated.

Preset Level

Each of the presets in the RP1000 can have a specified programmed level. To change the level of
a preset, follow these steps:
From the preset name display, press the Edit Down button once. The Wah row will be lit.
1.
Turn Knob 6 to change the Preset Level parameter.
2.
3. Store these changes to the preset using the Store procedure if these changes are to be
recalled later.

Bypass

Any preset in the RP1000 can be bypassed using the preset footswitches. Bypass will defeat all
amp and effects modeling an output an unprocessed bypass signal. Bypass can be selected any
time during performance or editing.
1. Press the currently active preset's footswitch. The display will read bypass and unpro-
cessed guitar signal will be heard on all outputs.
2. Press any footswitch again to exit bypass and return to the last state (edited or unedited)
the RP1000 was in.
When a preset is bypassed, any devices connected to the Amp Loop and Stomp Loop will still be
active, meaning you can use bypass to kill all effects in the RP1000 without bypassing your core
tone.
33