Panasonic FV11VF2 Installation Instructions Manual page 7

INSTALLATION (JOIST MOUNTING- ) CONTINUED
5. Remove the lighting cord out from hook (FV-11VHL2),
then remove junction box plate and secure conduit or
stress relief to wiring box knock-out hole.(Fig.5)
6. Refer to wiring diagram (Page.5)
Follow all the local electrical safety codes. As well as
the National Electrical Code (NEC).
Using UL approved wire nuts, connect house power
wires to ventilating fan wires (Fig.6):
Black to black; white to white; green to green.
Make sure all connections are fastened firmly after
wiring is finished.
Replace the junction box plate, and then replace
lighting cord to hook. (Fig.5)
7. Install the circular duct (4 inches) to the adaptor and
secure it with duct tape or clamps. (Fig.7)
8. Finish ceiling work. Ceiling hole should be aligned
with the edge of the flange. (Fig.8)
9. Install the fluorescent lamps and then install the
night lamp. (Fig.8)
10. Insert mounting springs into slots as shown and
mount grille to fan body. (Fig.9)
Note:Do not mount grille and springs conversely. If
the grille is mounted in the opposite direction,
the grille can not be fitted to the ceiling, so
then reverse the grille position and try to
mount again.
(Fig.10)
Lighting cord
Hook
Black to black
Junction box plate White to white
Black to black
White to white
Conduit
Fan body
Joist
4 Long screws (ST4.2X20)
Night lamp
Slot
Correct
Incorrect
For Model FV-11VHL2
Screw driver
Junction box
plate
Screw
Fig.5
White to white
Black to black
Green to green
Wire nut
Black to black
Junction box
Conduit
Fig.6
Circular duct
Duct tape
or clamps
Fig.7
Fig.8
Fluorescent lamp
Mounting spring
Fig.9
Grille
Switch Switch
labels labels
Fig.10
For Model FV-11VH2