Changing The Tablet Underlay - Wacom GRAPHIRE 3 User Manual

CHANGING THE TABLET UNDERLAY

Your tablet comes with a printed underlay that can be seen through the transparent photo frame cover. You can
replace the underlay with a favorite photo or design of your own by following these steps:
1. Using your fingernail, carefully unsnap the photo
frame cover from either the left or right side of the
tablet and remove it.
2. Lift away the printed underlay and replace it with a
new photo or design of your choosing.
3. When you are done, carefully replace the photo
frame cover by inserting the tabs on the cover into
one side of the tablet and gently pressing down on
the opposite side until both tabs lock into place.
This will protect your photo or design as you work
on the tablet.
If you would like to customize the look of Graphire3
with your own artwork or photos, see
Tablet Underlay.
Note: You can trace or digitize an image either by
placing it on top of or beneath the photo frame cover.
The thickness of the item to be traced or digitized
should be 1 mm or less.
If you will be placing your image beneath the photo
frame cover for tracing, first remove the photo frame
cover and position the image to be traced so that it fits
within the active drawing area of the tablet. Then
replace the photo frame cover and begin tracing in
your favorite graphics application.
C
ONTENTS
I
NDEX
Creating a New
W G
ORKING WITH RAPHIRE
Page 25
3