Table of Contents
Advertisement
•
Passphrase: If you want to generate a key instead of entering a
key manually, type a passphrase in the field. You can enter up to
32 alphanumeric characters. Then click Generate. A valid key
appears in each of the Key 1 - Key 4 fields.
•
Key 1 - Key 4: If you did not use the Generate feature, enter a
valid WEP key. Do not leave a field blank, and do not enter all
zeroes; they are not valid key values.
-
-
Keep the default values for all other settings.
S
6
TEP
Click Save to save the changes.
S
7
TEP
To test the wireless setup, use the wireless client on any computer
S
8
TEP
to enter the correct SSID and shared key for your wireless
network. Verify that you can connect by entering a website
address, such as www.cisco.com.
Congratulations! The installation of the Wireless-G VPN router with
RangeBooster is complete. For more advanced settings and security
options, refer to the Administration Guide (see
page
13).
7
Suggested Next Steps
The WRV210 is ready for use. It is not necessary to change any settings.
However, the following steps are recommended:
• To protect your network, Cisco recommends that you reset the
administrative password. Click Administration > Management in the
navigation tree. In the Admin Password field, enter the new password.
Enter it again in the Re-enter to confirm field. Click Save to save your
.
settings
12
If you chose 64-bit WEP encryption, the key must be
exactly 10 hexadecimal characters in length.
If you chose 128-bit WEP encryption, the key must be
exactly 26 hexadecimal characters in length. Valid
hexadecimal characters are "0" to "9" and "A" to "F".
Cisco Small Business WRV210 Quick Start Guide
Where to Go From Here,
Advertisement
Table of Contents
