English
2. Attach the rubber feet to the printer as shown in illustration 33.
3. Attach fixing plate B to the printer as shown in illustration 34.
33
4. Pass the cable for the
DM-D500 through the hole
on fixing plate A, and fix
the cable at the bottom as
shown in illustration 35.
5. Connect the cable for the DM-D500 to the DM connector on the
TM printer as shown in illustration 36.
6. Attach fixing plate A to the TM printer using the stopper.
When you attach the stopper, insert the projections on the
stopper into the holes of fixing plate B. Fixing plate A can be
attached on either side of the printer. (Illustration 37 shows
fixing plate A attached to the right side of the printer.)
36
12 DM-D500 Installation Guide
34
35
37