Operation Method; Trial Run - Delta Electronics AC Motor Drive VFD007S23A User Manual

Chapter 3 Start Up| VFD-S Series

3.2 Operation Method

Refer to 4.2 How to operate the digital keypad and chapter 5 parameters for setting. Please choose
a suitable method depending on application and operation rule. The operation is usually done as
shown in the following table.
Operation Method
Keypad
Operate from
external signal

3.3 Trial Run

After finishing checking the items in "3.1 preparation before start-up", you can perform a trial run.
1. After applying power, verify that the display shows "F60.0".
2. Setting frequency to about 5Hz by using
3. Pressing
should press
STOP/RESET
press
4. Check following items:
If the results of trial run are normal, please start the formal run.
3-2
Frequency Source
AVI, ACI
RUN
key for forward running. And if you want to change to reverse running, you
key in
key.
Check if the motor direction of rotation is correct.
Check if the motor runs steadily without abnormal noise and vibration.
Check if acceleration and deceleration are smooth.
MI2
Parameter
setting:
MI3
4-05=10
4-06=11
GND
key.
page. And if you want to decelerate to stop, please
Operation Command
Source
RUN STOP/RESET
External terminals
input:
M0-GND
M1-GND
Revision August 2006, SE08, SW V2.61