Hoover SH40060 Owner's Manual page 10

post-Motor filter
CAUTION
!
To reduce the risk of personal injury, unplug
vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place.
when to Clean
It is recommended that the Pre- and Post-Motor
filter should be checked and cleaned periodically
depending on the frequency of use and the volume
of dirt being picked up on each occasion.
how to Clean
3.10 The Post-Motor filter is located on the rear of the
vacuum cleaner. Remove Filter door to access filter.
3.11 Remove Post-Motor filter.
3.12 Gently tap the filter on the inside of a trash
receptacle to remove dust and dirt.
3.13 Hold filter under running water to clean.
Place Post-Motor filter back into rear of vacuum
cleaner and replace filter door.
what to buy: post-Motor filter
If desired, additional filter is available. Ask for
®
Hoover Part No. 304286001.
Actual model may vary from images shown.
3.10
!
3.12
Both Pre- and Post-Motor Filters can be rinsed
in warm water (max 40°C). Allow to air dry for
24 hours before replacing. Do NOT use any
detergents or boiling water to wash filter.
10
3.11
3.13
IMPORTANT