Maintenance Filter Bag Replacement - Hoover S3592 Owner's Manual

2-11
K
J
With the cleaner standing on end, the
wand holder (J) may be inserted into
the slot (K) on the bottom of the cleaner
body as shown.
3-2
B
How to replace
Turn cleaner off and disconnect from
electrical outlet.
Disconnect hose from the cleaner,
pressing the button (B) on the hose con-
nector and pulling straight out.
3-5
E
Press on filter bag clamp (E) to release
bag from frame.
Discard used bag. Be careful not to
dispose of filter bag frame.
6
3. Maintenance
Filter bag
When to replace
3-1
A
Check the bag when the full bag indica-
tor (A) shows red. When bag is filled
with dirt, the cleaner will not operate
efficiently. Discard used bag.
CAUTION: Very fine materials, such
as face powder or cornstarch may
seal the filter bag and cause it to
burst even though it is only partially
full of dirt. When using the cleaner
to remove material of this nature,
change the bag often.
3-3
C
Open the filter bag door by pressing on
the latch (C).
3-6
F
Place new filter bag behind tabs (F) on
underside of bag frame.
Where to buy
Filter bags may be purchased from
Authorized Hoover Dealers (Depots),
Leading Retailers, Hoover Factory
Service Centers, or through Hoover, Inc.
online at www.hoover.com.
What to buy
In order to maintain the original cleaning
effectiveness and superior filtration qual-
ities of your cleaner, use only Genuine
Hoover® Allergen Filtration Type SR
disposable filter bags (package number
401010SR).
To assure that your HOOVER cleaner
operates at peak performance, it is
imperative that you use only genuine
HOOVER filter bags distributed by
Hoover, Inc.. HOOVER bags can be
identified by these trademarks --
®
3-4
D
Pull up on the filter bag frame (D) and
remove from bag compartment.
3-7
Return filter bag frame and filter bag to
bag compartment, making sure all sides
of filter bag are within the bag compart-
ment.
Close the bag compartment door and
reattach hose.
Do not operate cleaner without filter
bag in place.