Mackie CR-1604 Datasheet

XLR10•MIXERMIXER•ROTOPOD•REMOTE FADER
XLR1 0 EXPANDER
1. GENERAL CONFIGURA-
TION. The component shall
provide an additional 10
Balanced Microphone Inputs
for the Mackie Designs CR -
1604 16-channel Mic/Line
Mixer. Component shall
attach to the CR-1604,
forming a single, physically
and electronically integrated
component.
2. INPUTS/OUTPUTS. The
component shall include on
its rear panel, electronically
balanced mic inputs using
female XLR-3-type connec-
tors to accept nominal levels
of from –48dBU to +14dBU.
Each channel shall have a
rotary Sensitivity Control
adjustable from –4dB to
–48dB. There shall be a
phantom power supply with
separate switch to provide
+43/48V DC to all mic input
connectors for remote
powering of condenser
microphones.
3. PHYSICAL CONFIGURA-
TION. The component shall
be grey-black with alumi-
num/steel chassis, which
shall be mechanically
connected by metal screws
and electronically con-
nected by ribbon cable to
the CR-1604. The XLR10's
dimensions shall be 2.1" tall
by 17.34" wide (including
screw heads) by 2.6" deep.
4. SPECIFICATIONS. In
addition to specifications
previously cited, the XLR10
shall meet or exceed the
following performance
criteria: Frequency Response,
20Hz to 40kHz 1dB;
Distortion, less than 0.025%,
20Hz-20KHz; Mic Preamp
E.I.N., –129dBm; .
The component shall be a
Mackie Designs XLR10 for
the CR-1604 Mixer.
MIXERMIXER
1. GENERAL CONFIGURA-
TION. The combiner shall
mix the outputs from up to
three Mackie Designs
CR-1604 mixers (or equiva-
lent) and provide a single set
of combined outputs. The
combiner shall be capable of
being mounted horizontally
or vertically via integral
mounting tabs, or may be
placed on a table. The
combiner shall be entirely
self-contained including
power supply.
2. INPUTS/OUTPUTS. The
combiner shall have stan-
dard tip/sleeve unbalanced
jacks to accommodate
THREE INPUTS EACH for the
following: AUX 1 through 6,
ALT 3 and ALT 4, Monitor,
stereo headphones (tip=left,
ring=right) and Left and
Right Main Inputs. All inputs
®
2/6/98
MORE INFORMATION
THESE SPECIFICATIONS
ARE AVAILABLE ON 3.5"
PC & MAC FORMAT DISK IN
POPULAR WORD
PROCESSOR FORMATS
CALL 800/258-6883
FAX 425/487-4337
OUTSIDE THE U.S., CALL
425/487-4333