Carton Contents; Assembly Instructions - Delta A00543 Instruction Manual

Engine Frame
and Wheel
Assembly
Engine
High Pressure
Hose
1. Place the nozzle holder onto the
panel (located on the handle
assembly) and push each nozzle
holder into place.
2. Remove five colored quick
connect nozzles from plastic bag
and insert them into correct
grommet on the nozzle holder.
NOTE: Nozzles are color coded to
match colored nozzles on panel.
3. Place handle assembly onto frame,
depress the snap buttons, and slide
the handle assembly onto the frame
until snap buttons snap into place.
4. Attach high
pressure hose to
gun. Tighten
securely.
A00543

CARTON CONTENTS

Handle
Spray Gun
Oil

ASSEMBLY INSTRUCTIONS

English/
Spanish
Operator's
Chemical
Manual
Hose
Engine
Manual
Nozzle
Holder
5. Connect wand to gun. Tighten
securely.
6. Add engine oil (supplied) to engine.
Refer to Engine Owners Manual
supplied by engine manufacturer for
correct procedure.
NOTE: There will be a slight amount of
oil in the engine from factory testing.
NOTE: The high pressure pump was
filled with oil at the factory. There is no
need to add oil at this time, see the
Maintenance section of this manual
for Maintenance information.
and replaced with the dipstick/oil
plug before operating pressure
washer.
7. Using a 17 mm
wrench, remove
shipping plug from
pump by turning it
counterclockwise.
Discard plug.
8. Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
6- ENG
Nozzle
Cleaning
Tool
Bagged Parts
Quick Connect Spray Wand
The shipping plug
must be removed
Quick
Connect
Nozzles